Product Details
Cement Ultra Durable ELRS 2.4G receiver is a high-performance receiver specially designed for fpv drone. It has anti-reverse connection function,IP67 dustproof and waterproof rating, and 100mW power amplifier(PA), bringing a powerful, stable and reliable remote control experience.
Check out all our Receivers and the rest of our DarwinFPV Products!
ELRS receiver and FC wiring diagram:
Betaflight Setup:
- Open the Betaflight Configurator, go to the "Ports" tab and enable the corresponding UART as "Serial Rx" Save and reboot.
- On the "Receiver" tab, click "Serial Receiver Provider " on the Receiver panel and select "CRSF".
Receiver bind method:
- The receiver is powered on and off for 3 consecutive times (within 1 second interval);
- The LED light of the receiver flashes twice, indicating that the receiver has entered the binding mode;
- Put the TX Module or the remote controller into the binding state. Once the LED status becomes steady on, the binding is successful.
Specifications:
- Weight: 3.0g±0.2g
- Size: 14.2mm x 22.0mm x 4mm
- Packet Rate: 2.4GHz ISM
- RF: 100mW
- Voltage: 5V
- Current: 60mA
- Protocol: CRSF
- Firmware: BETAFPV_Nano_2400_RX
- Chip: ESP8285、SX128X、AT2401C
- Antenna:Mini T antenna(50mm)
- The receiver's factory firmware is ELRS_V3.2.0
Package Includes:
- 1 x DarwinFPV "Cement" Ultra Durable 2.4G Receiver
- 1 x Silicone cable (length 70mm)
- 1 x Transparent heat shrink tube (length 50mm, diameter 14mm)