TBS Podracer AIO Flight Controller

Regular price $69.95 Sale

Availability: Available Unavailable

Product SKU: 36C-9414

Product Details

The TBS Podracer AIO is a powerful whoop board designed to cater for TBS Pro32 Nano VTX and TBS Crossfire / Tracer Nano RX with direct pin-header installation. The result is a clean, compact and lightweight core for your build.

TBS partnered with Zeez to make this awesome whoop AIO. Introducing the the TBS Podracer AIO, the board is designed to cater for TBS Pro32 Nano VTX and TBS Crossfire / Tracer Nano RX with direct pin-header installation. The result is a clean, compact and lightweight core for your build..

The FC is equipped with F4+MPU6000 and the ESC is capable of True 30A current running BLHeli32. This board is versitle enough to run on your cinewhoop, 4/5" racer like the podracer and longrange cruiser like the TBS Aureo. 

Check out our TBS Podracer Frame and Partsall our Whoop Style AIO Boards and the rest of our TBS Products!

FC Specifications:

  • Mounting holes: 25.5×25.5 mm / M2 holes
  • Up to 6S input
  • 5V BEC up to 1.2A continuous
  • STM32F411 MCU (Support BetaFlight, EmuFlight)
  • MPU6000 Gyro/ACC
  • OSD chip Onboard (AT7456E)
  • 2 available UART
  • LC Filter for 5V VTX and Camera
  • Direct solder connection for TBS Nano RX and TBS Unify Pro32 Nano
  • Support programmable LED like WS2812 etc
  • Built-in current sensor

ESC Specifications:

  • Signal support: PWM, Oneshot125, Oneshot42, Multishot, Dshot150, Dshot300, Dshot600
  • Input voltage: 2S-6S Lipo
  • Continuous current: 30A
  • Peak current: 35A
  • ESC firmware: BLHELI 32
  • PWM Frequency Range: 24KHz up to 96KHz

Package Includes:

  • 1 x TBS Podracer AIO 
  • 1 x Capacitor 
  • 1 x AWG cables set with shrink tubes
  • 4 x mounting gromets
  • 1 x XT60 (Male)
  • 1 x XT30 (Male)
  • 1 x Pinheaders set for TBS VTX and RX

GPS INSTALLATION:

Because of the phyiscal limitations, installing a GPS module to the FC will require a few extra steps to remap the board's resources. 
Note: The follow steps will disable LED and FC's SmartAudio and use as softserial for GPS.  

HOW TO:

        1. Flash the board with Target: STM32F411

                      

        2. Download the Config file [HERE]. Then load it the board. 

        3. Wire the GPS as shown 

                      


Warranty Policy:

If any warranty needs for this product arise, please note that the manufacturer of this product is one of the few manufacturers we carry that requests the end user to contact them directly for any troubleshooting or possibly defective items. We must follow these policies set by these manufacturers. Please make sure to contact them directly if you feel your product is defective in any way. Reach out to us if you need an email address or contact link for this manufacturer.

Loading...
x