The Cricket200 V2 F7 Flight Controller is finally here, This second generation Cricket flight controller is optimized compared to the first generation. New Layout but we keep the same solder pad configuration. Gyro change to BMI270 so far is the best to replace MPU6000. Power unit optimization provide better and cleaner power for internal and external power support. It also support HD and Analog configuration, same as the first generation.

Check out the rest of our 20x20mm Flight Controllers and NewBeeDrone Products!

Specifications:

2xBMI270 Gyro
STM32F722 216mhz
3-6S direct battery input
5V 3A,
3V3 100mA
9V 2A 18W Design for DJI FPV Air Unit
5V Camera Power
BetaFlight OSD
31.5x27 CB with 20x20 mounting holes, weight: 5.85g
6 UARTS on board.
UART1 (Only RX, Air Unit connector)
UART2 (Free)
UART3 (Free)
UART4 (TX and RX connected together for F.Port)
UART5 (Only RX, ESC Telemetry)
UART6 (MSP/Configuration Port for Air Unit)
Built-in 4 IN 1 ESC socket(including ESC telemetry, External current sensor) JST1.0 8Pin
Plug and plug with NBD Cricket200 ESC/Infinity200 ESC. Also compatible with most of the ESC on the market.
Built-in solder pads for ESC signal output and power
Printed layout instructions ON the board - no need for instructions!
DJI FPV Air Unit socket (use UART1 and UART6)

Includes:

1x Cricket200 FC F7 flight controller
4x Grommets short 4x Grommets Long
1x Cricket200 FC to DJI Air module cable 70mm

Firmware can be downloaded HERE.

NewBeeDrone Cricket200 F7 V2 Dual BMI270 Flight Controller - 20x20mm