There is nothing like the experience of flying an FPV drone, but building these marvelous machines is more complex than it needs to be. With Tramp, we set out to raise the bar on video transmitter technology. With Ghost, we set out to redefine the norms in receivers for R/C control. And now we have fused these two together, in the groundbreaking Ghost Hybrid. Designed by pilots, built by pilots, supported by pilots.
Check out all our IRC Ghost Products and the rest of our ImmersionRC Products!
Features:
- 20x20, 25.5x25.5 mounting
- single sided, with included gummies, for extremely low profile mounting
- Two full receiver channels (not just dual antenna)
- Only 2.2g, perfect for the popular sub-250g class
- Extreme Range AND Low Latency
- 500Hz R/C Link Updates (HW is 1kHz ready)
- 2.4GHz Lora OR FLRC control modes, for the best performance in any environment
- Integrated 5.8GHz 25mW - 600mW Video Transmitter
- All 48 standard channels
- Thermally Regulated, Factory Calibrated
INTELLIGENT VTX CONTROL
Intelligent, and direct control of the video transmitter from the Ghost ecosystem. Use either the OLED menus on the Ghost Transmitter module or the responsive OpenTx tools menu. Tx remains silent on power-up, shuts down immediately in an (unlikely) failsafe.
LOCKING CONNECTORS
Innovative locking connectors deliver the advantages of the light-weight u.FL/MHF standard, with the security required for world-class racing, or long-range flying. Simply plug the connector onto the board, and slide the locking cap to secure.
THERMAL REGULATION + CALIBRATION
As with all tramp products, the Hybrid includes automatic thermal regulations, protecting the video transmitter against potentially damaging overheating while sitting on the starting pad. The on-board Tramp is factory calibrated, for precise power delivery during critical race events.
qTee ANTENNAS
qTee, a.k.a ‘Cutie’ antennas are center-fed dipoles, with integral balun to ensure no cable radiation, and without unexpected nulls in the radiation pattern. Tip to Tip length of just 60mm, easy to install in anything from a Whoop™ to an X-Class quad
Specifications:
- Downlink RF Power: +13dBm
- Sensitivity: -117dBm in Long Range mode
- Serial Formats: GHST, SBus, SBus-Fast (200k), SRXL-2 (400k), SBus Inverted
- Firmware: Over-the-air (OTA) upgradeable (Rx and VTx)
- Power Supply: 5V, with Over Voltage Protection
- VTX Control: Automatic, via Ghost
- Antenna Connectors: Standard U.FL with Locking Connectors
Manual:
Firmware/ Downloads:
Package Includes:
- 1x Immersion RC Tramp/Ghost Hybrid V2 UNO 5.8GHz vTx/2.4GHz Rx
- 2x qTee Antenna
- 1x Silicone Cables
Laws and requirements regarding transmission of radio waves vary greatly across the world.
In some countries, this product may not be legal. In the USA, the operator of this product is required by law to have a
HAM amateur radio license, at the very least.
It is the operator's responsibility to make sure that they are using this product in a legal manner, or not using it at all if not possible to do legally in their location.
By adding this product to your cart, you are confirming that you have read this notice, and that Pyrodrone is in no way responsible for the actions of the operator while using this product.
Warranty Policy:
If any warranty needs for this product arise, please note that the manufacturer of this product is one of the few manufacturers we carry that requests the end user to contact them directly for any troubleshooting or possibly defective items.
We must follow these policies set by these manufacturers. Please make sure to contact them directly if you feel your product is defective in any way.
Reach out to us if you need an email address or contact link for this manufacturer.
