The Happymodel Moblite7 HDZero Whoop is a 75mm HD brushless whoop weighing just 29.5 grams. It features the HDZero Whoop Lite VTX and Nano Camera and built-in SPI ELRS 2.4GHz or FrSky 2.4GHz receiver.  With powerful EX1002 KV20000 motors, and Superbee F4 Lite flight controller, this should be a great performing high-definition whoop you can fly just about anywhere.

Check out our Micro Whoop Drones and our entire Happymodel Collection!

FC Specifications:

• SPI ELRS version Firmware target: CrazybeeF4SX1280
• MCU: STM32F411CEU6 (100MHz, 512K FLASH)
  
• Sensor: ICM42688P
  
• Power supply: 1S Lipo Lihv battery input (DC 2.8V~4.35V)
  
• Built-in 5A(each) Blheli_S 4in1 ESC Dshot600 ready
  
• Built-in Betaflight OSD(SPI Control)
  
• Built-in SPI Frsky/ExpressLRS receiver
  
• Built-in 5V 1A BEC
  
• Built-in voltage detection

4-in-1 ESC Specifications:

• MCU upgraded to EFM8BB21
  
• Power supply: 1S LiPo/LiPo HV (2.8v~4.35v)
  
• Currents: 5A continuous peak 6A (5 seconds)
  
• Support BLHeliSuite programmable
  
• Factory firmware: O_H_5_REV16_8.HEX
  
• Default protocol: DSHOT150/DSHOT300/DSHOT600

ELRS SPI Receiver Specifications:

• Packet Rate option: 25Hz/50Hz/150Hz/250Hz/500Hz
  
• RF Frequency: 2.4GHz
  
• Telemetry output Power: <12dBm
  
• Receiver protocol:  SPI ExpressLRS
  
• Could bind with ELRS V2.0 firmware TX module

FRSky SPI Receiver Specifications:

• SPI BUS receiver Frsky D8/D16 compatible
  
• Compatible Non EU transmitter D8 model and EU-LBT(Frsky_x_lbt)
  
• Channels: 8ch or 16ch
  
• Failsafe support
  
• No ground interference ( Transmitter and receiver 1 m from the ground): 100m~200m
  
• Based on CC2500 RF module Compatible with Futaba S-FHSS , Redpine protocol

Motor Specifications:

• Model: EX1002 20000KV
  
• Configuration: 9N12P
  
• Stator Diameter: 10mm
  
• Stator Length: 2mm
  
• Shaft Diameter: Φ1.5mm
  
• Motor Dimension(Dia.*Len): Φ13.5mm*12.5mm
  
• Weight(g): 2.5g
  
• No. of Cells(Lipo): 1S only

Gemfan 1610-2 Propeller Specifications:

• Weight: 0.24g
  
• Material: PC
  
• Pitch: 1 inch
• Props Dia: 40mm
  
• Center Hole Dia: 1.5mm

HDZero Nano Lite Camera Specifications:

• Dimensions: 14x16x11 mm
  
• Weight: 1.5gram
  
• Sensor: 0.5 inch, up to 10650 mV/Lux-sec ultra-high sensitive CMos sensor
  
• Excellent low light performance
  
• FOV:
  4:3: D:130° H:108° v:84°
  16:9:D:122° H:108° V:65°

HDZero Whoop Lite VTX Specifications:

• 1S Input
  
• 25mW/200mW RF Output-SmartAudio Support
  
• 25.5×25.5 M2 Soft Mounting- Antenna Retention
  
• Removable Shielding Box- 32.5×32.5mm(29x29mm inner)
  
• 4.5grams/4mm Thickness (without shielding)

Package Includes:

• 1 x Happymodel Moblite7 HDZero 1S 75mm Brushless HD FPV Whoop Drone - Chosen Receiver
  
• 1 x Moblite7 Spare Canopy
• 1 x Gemfan 1610 propeller Set (4cw+4ccw)
• 1 x Propeller disassemble tool
  
• 1 x Screwdriver