Click here!
Tiny Ape Freestyle is the first 2.5'' drone for Darwinfpv. In order to meet the needs of more friends and we have made multiple attempts. It comes with the Darwin ELRS2.0 F411 15A Bluejay AIO and the VTX006 which has 25-600mW output power.
NOTE: Runcam Thumb Camera NOT Included
Check out all our Analog BNF Drones and the rest of our DarwinFPV Products!
The RunCam Nano 4 uses a 1/3'' CMOS sensor, 2.1mm lens and 800TVL resolution for better realistic color and clearer low-light night vision.
1103 8000KV Brushless motor is only 3.7g and it’s power and thrust are surprising, and the flight time can achieve about 5 Minutes. We have notice: the motor only supports 2S batteries, and if it is connected to 3S to push the throttle too much, the motor will be permanently damaged.
|
380mah(3S) |
450mah(2S) |
|
| Landing voltage |
9.75V |
6.5V |
| VTX Power |
400mW |
400mW |
| Fly Time |
5.25min |
5.18min |
VTX006 has 25-600mW output power and can provide stable images and powerful transmission. You can choose the perfect output power according to you FPV requirements. ( The default setting of the output power for Tiny Ape is 400mW)
|
Red light flashes frequency
|
Power |
|
1 |
25mW |
|
2 |
200mW |
|
3 |
400mW |
|
4 |
600mW |
This is an updated version of Darwin AIO. We integrated the ELRS receiver on the FC to make it easier to apply to mini drones. The ESC adopts Bluejay firmware, compatible with 1-3S Lipo input, 15A continuous current and 17A peak current. FC provides 2 sets of Uarts interfaces, and also provides various external device interfaces such as SBUS, Softserial, CTR, BUZZ, RGB, etc., which perfectly solves the problem of insufficient number of F411 Uarts.
The built-in receiver is an SPI protocol receiver, so you need to select SPI receiver support (SPI RX support) in the betaflight configurator. Under normal circumstances, the checkbox on the betaflight configurator receiver is empty. If the betaflight configurator used is 10.8.0 and above, the checkbox should select "EXPRESSLRS". As shown below:

Note: The factory AIO firmware only supports ELRS_V2.0, and can be used with ELRS_V2.0 version TX. The firmware file name of ELRS-V2.0 is BETAFPVF4SX1280
Darwin AIO 002 FC Pairing Tutorial
Overall rating: 4.285714 / 5 from 14 reviews.
Review topics: ["quad","guy","fun","drone"].
"This little quad is amazing! Sadly i got water on my usb port and it shorted out the board but man i would pick this thing again. The 600mw VTX is enough to make you say this is analog? I ran a multiGP course with it and it handled really well."
"This thing suck"
"I just a regular person but they do help and take care of there customers The shipping is fast and product are as they Say thanks and merry Christmas!!!!"
"Great fun! Super powerful!"
"Great 2.5 quad for a beginner like me. Love the fact that it has ELRS."
"This is one fun little beast of a quad! Took a bit of wrestling with help from a friend to update and get working using BF4.4 so it would work with my Boxer, but once connected it's been super fun to fly. Just like a bigger 4" or 5" quad...only smaller :) I get a little over 7 minutes of flying using R-Line 550mah batteries which is more than adequate to me. Video reception feels a bit spotty when at high altitude, and I may need to recheck my power settings or upgrade the antenna."
"Not the best I didn’t like the flight controller on this bnf."
"This is fun and can take beating"
"Bout this quad to start me into this hobby. So far I've ran about 6 packs of 450mah 2s batteries through it. Hope a firmware comes out soon for it to bring it to ver3 ELRS, as I had to flash down my brand-new RadioMaster tx16s to version 2 to get them to pair up (made me extremely nervous doing that). Not a big deal to me yet, but did take me a few hours to figure out that was my problem. I did bust a motor shaft the last time I was out from doing a hard roll, running it too close to the ground at full speed. Which for as many times as I hit the ground hard trying to learn how to fly in the real-world, I'm honestly surprised how well it held up until that point. No big deal, working on getting T- motors for it the same size & KV. Heard that was a great upgrade for them. Out of the box essentially, once I started to get use to it real world flying, it flies amazingly well even in 15 to 20mph wind. Nano Camera does really well. VTX has great output. Did very well getting a signal to my FatShark Scout goggles."
"If you're running the latest ELRS 3.x you are in for a headache. This FC comes with ELRS V 2 and Betaflight 4.3 firmware. If your module is on 3.x you will have to flash to Betaflight 4.4. Oh but the target indicated by DarwinFPV has the wrong target listed SMH (correct target is DARWINF4SX1280). Then BF 4.4 won't support the Darwin VTX lol. You can set a UART to smart audio and it will work but it will not change Bands or Frequencies. currently stuck on R6. I'm sure this was a great BNF when ELRS 2.0 and BF 4.3 were a thing. Unfortunately they have yet to future proof this little guy. To be fair they do indicate the ELRS version on the listing and I missed it before the purchase."
{"one"=>"Select 2 or 3 items to compare", "other"=>"{{ count }} of 3 items selected"}