Skystars F7HD Stack F722HD Pro 5 OSD & AM60 AM32 4in1 ESC - 30 x 30mm

Skystars F7HD Pro5 Flight Controller

• MCU: STM32F722
• Gyroscope: ICM42688
• Baro:Bmp280
• OSD: Betaflight SPI OSD DJI HD OSD(UART6)
• Black box: 16MB
• 6x Uarts: UART 1/2/3/4/5/6
• 4x PWM outputs
• 1x I2C
• 3x LEDs for FC STATUS (Blue, Green) and 3.3V indicator(Red)
• USB Type-C(USB2.0)
• 1x JST-SH1.0_8pin connector (Gnd/Vbat/S1/S2/S3/S4/Rx3/Curr)
• 1x JST-SH1.0_6pin connector (R1/G/R6/T6/G/10V)
• VTX 10V/Vbat filtered power ON/OFF switch
• DJI FPV OSD is supported by any spare UART
• LED: 4 LED independent pads, support WS2812 programming lamp output.
• Receiver: Support Sbus, crsf, ibus, SBUS, XBUS, support 3.3v Spektrum satellite receiver, The default receiver input is UART1(You can solder ELRS RX on UART1), F7 has a built-in inverter, which can actually be installed in any spare UART.
  

Power:

• Input voltage: 3-6S
• BEC: 5V/10V 3A max dual-channel BEC supports stable power supply on the sky side of DJI
• LDO 3.3V: Max.250mA

FC Firmware:

• BetaFlight firmware: SKYSTARSF722Pro
• INAV firmware:SKYSTARSF722HD

Mounting:

• Installation size: 30.5mm × 30.5mm The installation hole is M4 and supports shock column installation
• External size 39mm × 39mm
• Flight control weight: 6.9g
• Flight control onboard voltage sensor.

AM60A AM-32 32bit 4-in-1 ESC

• Support Dshot1200, Dshot600, PWM control signal
• Input voltage: 3-6S LiPo
• Con.Current: 60A
• Peak Current: 80A¡Ý 10S
• Firmware: AM_32
• Support : Dshot 600/1200
• Mounting hole : 30.5mm/M3
• BEC: No
• Product size: 41*46*7.6mm
• Weight: 18g

• 1 x SkyStars Fly Stack - F722 HD Pro 5 FC + AM60 60A AM_32 ESC - 30x30
• 8 x Silicon grommets M4 to M3
• 2 x JST-SH1.0_8pin cable, 4cm
• 1 x JST-GH-6P cable for DJI port, 10cm