HappyModel BNF Moblite7 Whoop - FrSky

The Moblite7 is one of the most streamlined low-profile BNF whoops available on the market. This 75mm lowrider boasts a RunCam Nano 3 camera along with a VTX capable of up to 200mW, the extremely light AIO FC powers the unibell 0802 motors.

This whoop is a blast, with plenty of power and quality video.

Check out all our Analog BNF/PNP/RTFs and the rest of our HappyModel Products!

Features:

• The lightest 1s 75mm brushless whoop
• Powerful and efficiency
• The lightest 1s AIO 5IN1 F4 flight controller
• New Unibell EX0802 brushless motors
• Low profile Canopy design
• VTX power switchable 25mw~200mw

Specifications:

• Wheelbase: 75mm
• Size: 97x97x25mm
• Weight: 19.5g (without battery)
• Weight: 36g (with Original 1s 650mah Lipo battery )

Motor:

• Model: EX 0802 19000KV ( New Unibell Version)
• Configuration: 9N12P
• Stator Diameter: 8mm
• Stator Length: 2mm
• Shaft Diameter:Φ1mm
• Motor Dimension(Dia.*Len): Φ10.5mm*14.9mm
• Weight(g): 1.7g
• No.of Cells(Lipo): 1S only

Flight Controller:

• (Frsky SPI RX Version) DiamondF4 FR FC Firmware Target: CrazybeeF4FR
• MCU: STM32F411CEU6 (100MHZ, 512K FLASH)
• Sensor: ICM42688P
• Original whoop size compatible
• Power supply: 1S battery input (DC 2.9V-4.35V)
• Built-in 5A(each) Blheli_S 4in1 ESC Dshot600 ready
• Built-in Betaflight OSD(SPI Control)
• Built-in 5.8G VTX
• Built-in SPI Frsky/Flysky receiver
• Built-in 5V 1A BEC

• MCU Upgraded to EFM8BB21
• Power Supply: 1S LiPo/LiPo HV
• Current: 5A continuous, peak 6A (3 seconds)
• Support BLHeliSuite programmable
• Factory Firmware: O_H_50_REV16_8.HEX
• Default Protocol: DSHOT600

Onboard Frsky SPI D8 receiver Version:

• SPI BUS Receiver Frsky D8 Compatible
• Compatible Non EU transmitter D8 model
• Channels: 8CH
• Failsafe Support
• No ground interference ( Transmitter and receiver 1 m from the ground): 200m~300m

Onboard Flysky Receiver Version:

• SPI BUS Receiver
• Protocol: AFHDS and AFHDS-2A Switchable
• Channels: 8CH (AFHDS) or 14CH (AFHDS-2A)
• No ground interference ( Transmitter and receiver 1 m from the ground): 100~200m
• Failsafe Support

Onboard 5.8G 40CH 25-200mW VTX:

• Output Power: 25mw~200mw switchable
• Frequency: 40CH
• Input Voltage: 3.3V 5.5V
• Current Consumption: 300mA (type)
• Frequency: 5.8GHz 5bands 40 channels (include Race band)
• Smartaudio Ready

Runcam Nano 3 FPV Camera:

• Image Sensor: 1/3" CMOS
• Horizontal Resolution: 800TVL
• Lens : 2.1mm(M8) FOV 160°
• Signal System: PAL/NTSC Non Switchable
• S/N Ratio: >50dB
• Electronic Shutter Speed: Auto
• Auto Gain Control (AGC): Auto
• Min. Illumination: 0.01Lux@1.2F
• D-WDR: Auto
• Day/Night: Color
• Power:DC 3-5.5V
• Current: 110mA@5V 120mA@3.3V
• Housing Material: ABS
• Net Weight: 1.2g
• Dimensions: L14mm*W14mm*H9mm

Lipo Battery:

• Capacity: 650mAh
• Voltage: 3.8V
• Continuous Discharge Rate: 30C
• Instantaneous Discharge Rate: 60C
• Size: 60mmx18mmx8mm
• Weight: 16g
• Connector: PH2.0

Package Includes:

• 1x HappyModel BNF Moblite7 Whoop - FrSky
• 2x 1S 650mAh LiPo Battery