The ESC is pretty much at it's final stage, the only difference you will see with the final batch will be lower profile wider spread new design heatsink.
Think of the current heatsink as a "place holder"
Final design heatsink will be available to be purchased separate.
(Early adopters will get 50% discount on the final edition Heatsink)
The main differences of the 4in1 compared to our current version are the following:
-New layout to make room for the heatsink
-Integrated LC FILTER for lower noise
It is also not mendatory to use the heatsink and is easily removable if the hight is a limiting factor in your build.
The final design of this ESC will retail for 54.99 so by purchasing the early adopter batch you will be saving over 15%
1 x PYRO32F3-45AV2 4in1 F3 32bit BLHELI ESC 4x45A
4 x Blue soft mount grommets
1 x Wire Harness (Plug N Play with Pyrodrone F4 OSD)
1 x 10cm 16AWG silicone wires
1 x XT60H Connector
2 x 35V 680uF Capacitors (Recommended for 6S setups)
1 x Manual
- 32bit ESC with BLHELI32 firmware
- Supports 3-6S lipo input
- PWM input, TLM supported
- Voltage output (VBAT)
- NO BEC
- Supports oneshot / Multishot / Dshot PWM
- Mounting holes 30.5x30.5mm
- Supports damped light
- F3 MCU, runs double faster than F051
- Extra Cap needed for high current or 6s usage
- Aluminum heatsink
- LC Filter