The Primo, was designed to take the current 1S and 2S EVEN 3S Brushless whoops guts, and plant them into a frame that pushes the limits of micro FPV. Designed to make the swap as simple and seamless as possible. I wanted something that could be swapped over in a matter of minutes, with no soldering required. The battery mounts are quick swappable, with 1 M2 screw. Swap from 1S to 2S, to 3S in seconds. Frames are stout, at 2mm's thick. However, as tough as the primo is, it's not indestructible, so replacement frames will be available separately. Each kit will include all hardware needed for a brushless whoop swap. Just add your Brushless whoop guts. Supports 16X16 stacks. Available in 080X and 110X flavors.
This 110X version does support both 9mm and 8.5mm 4 hole mounting pattern motors.
- An Insane weight of 10.3 Grams! (Including battery Mount, Camera mount)
- Primo 110X Frame
- Full set of 65mm Props
- Jelly FC Mount
- EOS2 Camera Mount
- AIO Camera Mount
- 1S/2S/3S Mounts
Supports the below models electronics (just add your favorite 4 pattern 110X motor):
- Eachine Trashcan
- Beta65 pro
- Beta65 Pro 2
- Beta65 X
- Beta75 Pro
- Beta75 Pro 2
- Snapper 6
- Snapper 7
UPDATES and NOTES:
- The Primo Canopy has been updated and will now support the EOS2 Camera, Runcam Nano, and Runcam Racer nano ( Runcam Nano adapters are NOT included, and are available separately). Eachine trashcan VTX is also supported, along with the Mobula7 AIO Camera. Alternative AIO cameras should fit the canopy with the included camera mount as well.
- If using the older Betafpv double stacks OR 16x16 stacks, you'll have to raise the canopy higher to allow for clearance. M2 standoffs will work perfectly.
Have your stack bound to your radio, before the transplant.
This version is for 110X motors with the 4 hole mounting patterns. Does NOT support three hole mounting pattern motors.