We only choose the best to pair with our Pyrodrone F4 OSD Flight Controller, and Spedix GS40A is definitely one of them.
The stack combo comes with the hassle free connecting harness so you won't have to figure out making your own connector or Re-pinning.
Also includes ESC Harness with one open end for those who like to solder on the FC side.
The Pyro F4/Spedix GS40 stack now ships with the new V2 Pyro F4 OSD that is compatible with the VTX pit feature of Betaflight.
Please refer to the below instruction to how use the VTX pit feature.
Version 2 Update:
The Pyrodrone F4 OSD has a new feature!
VTX Pit mode compatibilty.
In order to use this feature jump the two pads with solder on the "PIT" side ( If this feature is not needed then just jump the pads of the "ON" side and your VTX will always be on)
After you jump the PIT pads connect to Betaflight and go to CLI page , type in the following commands:
resource PINIO 1 A14
set pinio_box = 39,0,0,0
type "save" and then hit enter.
Wait for the FC to reboot, then go to the "MODES" tab in Betaflight and set VTX PIT MODE to an AUX channel you prefer
The Spedix GS40A-4IN1 is designed to be the best performance and reliability in the same product category.
To achieve the target, we use the lowest RDS standard size 5x6mm MOSFET with only 0.85mOhm resistance, making the ESC 40A capable in the real world. In contrast to the 30V MOSFET used by most competitors in the market, this 40V MOSFET improves the overall reliability in fast response to throttle signals. To meet the strict requirements in racing competition, we designed 50V power supply circuit and 5V clean output. To improve high current workload, we use high TG PCB of 6 layers even though the cost is much higher. On top of all these excellence in product designs, our engineers managed to control the dimensions to be the same as a standard 36mm flight controller board, without sacrificing the precious space in a quad. However, high performance is inevitably related to high costs in parts.
- Input:2-6 Cell LiPo
- Continuous Current: 40A
- Burst Current: 45A=10S
- Current Detection: Yes
- Firmware: BLHeli_32
- Dimensions: 38.5x43x6mm
- Weight:14.5 g
HyperLite F4 OSD