Please note, this Flight Controller is based on the ATF435 chip opposed the the F4's and F7's most of the community is used to. Downloading new drivers and using custom targets may be required.

As long as your BetaFlight 10.10 you should be good to go!

The iFlight Blitz ATF435 Stack/Combo provides dependable performance and efficient control of your 2-6S powered quadcopter. This 30x30 stack/combo features an ATF435 FC and 55A 8Bit 4in1 ESC to give you responsive controls and reliable power delivery. Fly worry-free and explore new heights. This flight controller comes with plug-in ports for 9V VTXs, LED/Buzzer, receiver, camera, & the ESC. The NEW ATF processors allow for a product like this, a 60-dollar stack that is feature-rich and comes with a 55Amp ESC, which is perfect for those amp-hungry builds.

Check out all our 30x30mm Flight Controller/Stacks and the rest of our iFlight Products!

To configure download ATBetaflight and if that does not automatically connect, here are virtual com port drivers. Future versions of Betaflight will fully support these boards.

Specifications

iFlight Blitz ATF435

MCU: AT32F435CGU7
Gyro: BMI270
Barometer: DPS310
OSD Chip: AT7456E
Flash: 32MB (Blackbox flash)
UARTS: 6
Motor outputs: 4x (SH1.0 connector)
I2C serial: SDA / SLA pads
Smartaudio / IRC Tramp VTX protocol supported
LED controller: Yes
Beeper pad: Yes
Firmware target: IFLIGHT_BLITZ_ATF435
Mount pattern: 30.5x30.5mm / 4mm PCB hole diameter
Dimensions: 36.5x35 mm
Weight: 7.8g
BEC: 5V 2.5A / 9V 2A

Blitz E55S ESC

Mounting Holes: 30.5x30.5mm/Φ4mm
Weight: 14.7g
Supports 2-6S lipo input
MCU: G071
Constant: 55 Amps
Burst: 65 Amp
Current sensor: Yes
BEC: No
Current rate: 200
Supports: DShot DShot150/300/600/MultiShot/ OneShot etc.
Target: Q-H-25 16.7(BlheliS) / Bluejay Q-H-50 (Bluejay)

Include

1x iFlight Blitz ATF435 E55S 2-6S 30x30 Stack/Combo (ATF435 FC/ 55A 8Bit 4in1 ESC)

iFlight Blitz ATF435 E55S 2-6S Stack/Combo (ATF435 FC/ 55A 8Bit 4in1 ESC) - 30x30