Product Details
The Moblite6 is insanely lite at only 26g with the 1s 300mah battery on board. The thrust to weight ratio is off the charts and is sure to be a blast when paired with the quality video that this quad provides.
Check out all our Analog BNF/PNP/RTFs and the rest of our HappyModel Products!
Features:
- The lightest 1s 65mm brushless whoop
- Powerful and efficiency
- The lightest 1s AIO 5IN1 F4 flight controller
- New Unibell EX0802 brushless motors
- Low profile Canopy design
- VTX power switchable 25mw~200mw
Specifications
- Wheelbase: 65mm
- Size: 80x80x25mm
- Weight: 18.5g (without battery)
- Weight: 26g (with Original 1S 300mAh Lipo battery )
Motor:
- Model: EX 0802 19000KV ( New Unibell Version)
- Configuration: 9N12P
- Stator Diameter: 8mm
- Stator Length: 2mm
- Shaft Diameter:Φ1mm
- Motor Dimension(Dia.*Len): Φ10.5mm*14.9mm
- Weight(g): 1.7g
- No.of Cells(Lipo): 1S only
Flight Controller:
- (Frsky SPI RX Version) DiamondF4 FR FC Firmware Target: CrazybeeF4FR
- MCU: STM32F411CEU6 (100MHZ, 512K FLASH)
- Sensor: MPU-6000 (SPI connection)
- Original whoop size compatible
- Power supply: 1S battery input (DC 2.9V-4.35V)
- Built-in 5A(each) Blheli_S 4in1 ESC Dshot600 ready
- Built-in Betaflight OSD(SPI Control)
- Built-in 5.8G VTX
- Built-in SPI Frsky/Flysky receiver
- Built-in 5V 1A BEC
- MCU Upgraded to EFM8BB21
- Power Supply: 1S LiPo/LiPo HV
- Current: 5A continuous, peak 6A (3 seconds)
- Support BLHeliSuite programmable
- Factory Firmware: O_H_50_REV16_8.HEX
- Default Protocol: DSHOT600
Onboard Frsky SPI D8 receiver Version:
- SPI BUS Receiver Frsky D8 Compatible
- Compatible Non EU transmitter D8 model
- Channels: 8CH
- Failsafe Support
- No ground interference ( Transmitter and receiver 1 m from the ground): 200m~300m
Onboard Flysky Receiver Version:
- SPI BUS Receiver
- Protocol: AFHDS and AFHDS-2A Switchable
- Channels: 8CH (AFHDS) or 14CH (AFHDS-2A)
- No ground interference ( Transmitter and receiver 1 m from the ground): 100~200m
- Failsafe Support
Onboard 5.8G 40CH 25-200mW VTX:
- Output Power: 25mw~200mw switchable
- Frequency: 40CH
- Input Voltage: 3.3V 5.5V
- Current Consumption: 300mA (type)
- Frequency: 5.8GHz 5bands 40 channels (include Race band)
- Smartaudio Ready
Runcam Nano 3 FPV Camera:
- Image Sensor: 1/3" CMOS
- Horizontal Resolution: 800TVL
- Lens : 2.1mm(M8) FOV 160°
- Signal System: PAL/NTSC Non Switchable
- S/N Ratio: >50dB
- Electronic Shutter Speed: Auto
- Auto Gain Control (AGC): Auto
- Min. Illumination: 0.01Lux@1.2F
- D-WDR: Auto
- Day/Night: Color
- Power:DC 3-5.5V
- Current: 110mA@5V 120mA@3.3V
- Housing Material: ABS
- Net Weight: 1.2g
- Dimensions: L14mm*W14mm*H9mm
Lipo Battery:
- Capacity: 300mAh
- Voltage: 3.8V
- Continuous Discharge Rate: 30C
- Size: 57mmx12mmx7mm
- Weight: 7.5g
- Connector: PH2.0
Package Includes:
- 1x HappyModel BNF Moblite6 Whoop - FrSky
- 2x 1S 300mAh LiPo Battery