The Rush Blade 60A 3-6S 128kHz BLHeli_32 4-in-1 ESC Extreme Edition by RUSHFPV features, front & back special process aluminum shell, F4 MCU 200MHz with BLHeli_32 Firmware, 24kHz-128KHz PWM frequency 3oz dual board and 40V rated MOSFET.

Check out our other Rush FPV Products and the rest of our 4in1 ESCs.

Features

BLHeli_32 firmware is the third generation of BLHeli firmware, following base BLHeli and BLHeli_S.
32-bit microprocessor running at a frequency of up to 200MHz for an excellent performance.
Supports up to 128K PWM frequency, so the response speed is faster and smoother, reducing mid-throttle oscillations.
Equipped with double-sided lightweight metal armor to avoid hardware damage caused by crashes, and the armor can effectively assist the MOSFET to dissipate heat.
Double PCB board design, high current circuit, and signal circuit are independent of each other.
All codes use damped light mode. Damped light does regenerative braking, causing very fast motor retardation, and inherently also causing active freewheeling.
Supports regular 1-2ms pulse width input, as well as Oneshot125 (125-250us), Oneshot42 (41.7-83.3us) and Multishot (5-25us).
Dshot signaling is supported at any rate up to at least Dshot1200. The input signal is automatically detected by the ESC upon power-up, No need for throttle calibration.
All codes use damped light mode. Damped light mode does regenerative braking, causing very fast motor retardation, and inherently also causing active freewheeling.
Supports beacon functionality, where the ESC will start beeping after a given time of zero throttles. This can be very useful for finding a lost drone.

Specifications

Rated Current: 60A
Peak Current: 80A
Input Voltage: 3-6S Lipo
MCU: F4 @ 200MHz
PWM FREQ: 24-128KHz
LED Color: Orange
Weight：16.5g
Dimension: 45*36.5*7.5mm
BL32 FW: RUSH_BLADE_EXTREME

Includes

1x Rush FPV Rush Blade 60A 128kHz 3-6S 32Bit 30x30 4in1 ESC - Extreme Edition

RUSHFPV Rush Blade 32Bit 60A 3-6S 128kHz 30x30 4in1 ESC - Extreme Edition